Front Seat Backrest Lower Rear Cover

Front Seat Backrest Lower Rear Cover

Removal

WARNING: Persons working on the supplemental restraint system (SRS) must be fully trained and have been issued with the safety guidelines.

WARNING: Allow a period of 10 minutes to elapse after disconnecting the battery before undertaking any work on the SRS.

WARNING: The SRS electrical connectors are unique. DO NOT force, or attempt to connect electrical connectors to the wrong sockets.

WARNING: The correct procedures must always be used when working on SRS components.

WARNING: It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.

WARNING: Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.

WARNING: Take extra care when handling SRS components.
1 Disconnect the battery ground cable. For additional information, refer to Specifications Battery and Charging System
2 Make the air bag supplemental restraint system (SRS) safe. For additional information, refer to Standard Workshop Practices Standard Workshop Practices
3 Remove the front seat. For additional information, refer to Front Seat Front Seat




4 Release the 2 lower tension straps from the front seat base.
- Reposition the front seat backrest cover for access.




5 Remove the front seat side trim panel support.
- Release the 2 clips.
6 Remove the seat control switch. For additional information, refer to Seat Control Switch Seat Control Switch




7 Remove the front seat backrest hinge cover.
- Remove the 2 screws.
- Release the clip.




8
NOTE:
Left-hand shown, right-hand similar.
Remove the 2 clips from the front seat backrest lower rear cover.




9 Remove the front seat backrest lower rear cover.
- Release the front seat backrest cover lower trim panel from the 2 clips.

Installation
1 Install the front seat backrest lower rear cover.
- Secure the front seat backrest cover lower trim panel to the 2 clips.
2 Install the 2 clips to the front seat backrest lower rear cover.
3 Install the front seat backrest hinge cover.
- Secure the clip.
- Install the 2 screws.
4 Install the seat control switch. For additional information, refer to Seat Control Switch Seat Control Switch
5 Install the front seat side trim panel support.
- Secure the 2 clips.
6 Secure the 2 lower tension straps to the front seat base.
- Reposition the front seat backrest cover.
7 Install the front seat. For additional information, refer to Front Seat Front Seat
8 Connect the battery ground cable. For additional information, refer to Specifications Battery and Charging System