Front Seat Head Restraint [Vehicles With: Head Restraint Video Display]
Front Seat Head Restraint
Removal
WARNING: Persons working on the supplemental restraint system (SRS) must be fully trained and have been issued with the safety guidelines.
WARNING: Allow a period of 10 minutes to elapse after disconnecting the battery before undertaking any work on the SRS.
WARNING: The SRS electrical connectors are unique. DO NOT force, or attempt to connect electrical connectors to the wrong sockets.
WARNING: The correct procedures must always be used when working on SRS components.
WARNING: It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.
WARNING: Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.
WARNING: Take extra care when handling SRS components.
1 Reposition the front seat backrest for access.
- Reposition the front seat head restraint to the fully extended position.
2 Disconnect the battery ground cable. For additional information, refer to Specifications Battery and Charging System
3 Make the air bag supplemental restraint system (SRS) safe. For additional information, refer to Standard Workshop Practices Standard Workshop Practices
4 Remove the front seat backrest lower rear cover. For additional information, refer to Front Seat Backrest Lower Rear Cover Front Seat Backrest Lower Rear Cover
5 Disconnect the front seat head restraint video display electrical connector.
- Release the clip.
6
CAUTION: Make sure that the head restraint is not withdrawn further than 15 mm (0.60 inch) from the head restraint guide tubes.
Release the front seat head restraint.
- Release the front seat head restraint from the head restraint clips.
7 Release the RH head restraint guide tube.
- Apply suitable protective tape around the RH head restraint guide tube.
- Using a suitable tool, release the RH head restraint guide tube.
8
CAUTION: Make sure no damage occurs to the video display wiring harness.
NOTE:
Note the position of the wiring harnesses to aid installation.
Remove the front seat head restraint.
- Feed the front seat head restraint video wiring harness through the front seat backrest cover and the seat frame.
Installation
1
CAUTION: Make sure the wiring harness is installed to its original position.
CAUTION: Make sure no damage occurs to the video display wiring harness.
Install the front seat head restraint.
- Feed the front seat head restraint video wiring harness through the front seat backrest cover and the seat frame.
2 Secure the RH head restraint guide tube.
- Remove the protective tape from around the RH head restraint guide tube.
3 Remove the suitable tape from the front seat head restraint post clip.
- Secure the front seat head restraint post clip to the RH head restraint post.
4
CAUTION: Make sure the plastic insert is correctly installed to the RH head restraint post. Failure to follow this instruction may result in damage to the vehicle.
Secure the front seat head restraint.
- Secure the front seat head restraint to the head restraint clips.
5 Connect the front seat head restraint video display electrical connector.
- Secure the clip.
6 Install the front seat backrest lower rear cover. For additional information, refer to Front Seat Backrest Lower Rear Cover Front Seat Backrest Lower Rear Cover
7 Connect the battery ground cable. For additional information, refer to Specifications Battery and Charging System
8 Reposition the front seat backrest to its original position.
- Reposition the front seat head restraint to its original position.