Fuel Pump Module

Fuel Pump Module

Special Service Tools






Wrench, Fuel Tank Module

310-118(LRT-19-009)

Removal

NOTE:
Removal steps in this procedure may contain installation details.
1 Disconnect the battery ground cable. For additional information, refer to Specifications Battery and Charging System
2 For additional information, refer to Fuel System Pressure Release - 5.0L Service and Repair
3 For additional information, refer to Fuel Tank Draining
4 For additional information, refer to Fuel Filter Service and Repair




5 TORQUE: 10 Nm




6
CAUTION: Before disconnecting or removing components, ensure the area around the joint faces and connections are clean. Plug open connections to prevent contamination.
TORQUE: 35 Nm
- Using the special tool, remove the fuel sender cover locking ring.




7
CAUTION: Take extra care not to damage the fuel tank level sensor float and arm.

- Depress the clips and release the lower part of the pump and sender unit rearward.
- Withdraw from the fuel tank.




8
CAUTION: Take extra care not to damage the fuel tank level sensor float and arm.


Installation
1 To install, reverse the removal procedure.




2
CAUTION: Make sure the fuel pump and sender unit is correctly installed in to the retaining bracket in the fuel tank.
CAUTION: Take extra care not to damage the fuel tank level sensor float and arm.
CAUTION: Install a new seal.
NOTE:
Make sure the locating tang is installed in the correct position.





3
CAUTION: Make sure the fuel pump and sender unit is correctly installed in to the retaining bracket in the fuel tank.
CAUTION: Take extra care not to damage the fuel tank level sensor float and arm.
CAUTION: Install a new seal.
NOTE:
Make sure the locating tang is installed in the correct position.