Camshaft Position (CMP) Sensor RH

Camshaft Position (CMP) Sensor RH
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures

Removal

NOTE:
Removal steps in this procedure may contain installation details.
1 Disconnect the battery ground cable.
For additional information, refer to Specifications Battery and Charging System
2 Raise and support the vehicle.
For additional information, refer to Thermostat Housing - Vehicles Without: Supercharger Service and Repair





Torque to: 10 Nm

Installation

CAUTION: Make sure that the mating faces are clean and free of foreign material.

CAUTION: Make sure that the sensor tip is clean and free of foreign material.

NOTE:
Lubricate the O-ring seal with clean engine oil.
1 To install, reverse the removal procedure.