Integrated Control Panel (ICP)

Integrated Control Panel (ICP)

Removal

WARNING: Persons working on the supplemental restraint system (SRS) must be fully trained and have been issued with the safety guidelines.

WARNING: Allow a period of 10 minutes to elapse after disconnecting the battery before undertaking any work on the SRS.

WARNING: The SRS electrical connectors are unique. DO NOT force, or attempt to connect electrical connectors to the wrong sockets.

WARNING: The correct procedures must always be used when working on SRS components.

WARNING: It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.

WARNING: Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.

WARNING: Take extra care when handling SRS components.

NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
1 Make the air bag supplemental restraint system (SRS) safe. For additional information, refer to Standard Workshop Practices Standard Workshop Practices
2 Disconnect the battery ground cable. For additional information, refer to Specifications Battery and Charging System
3 Remove the instrument panel upper section. For additional information, refer to Instrument Panel Upper Section Instrument Panel Upper Section




4 Remove the 4 screws securing the integrated control panel (ICP) bracket to the instrument panel.




5 Remove the ICP assembly.
- Disconnect the electrical connectors.
- Disconnect the co-axial cables.




6
NOTE:
Do not disassemble further if the component is removed for access only.
Remove the ICP from the ICP bracket.
- Remove the 4 screws.

Installation
1 Install the ICP to the ICP bracket.
- Install the 4 screws.
2 Install the ICP assembly.
- Connect the electrical connectors.
- Connect the co-axial cables.
3 Install the screws securing the ICP to the instrument panel.
4 Install the instrument panel upper section. For additional information, refer to Instrument Panel Upper Section Instrument Panel Upper Section
5 Connect the battery ground cable. For additional information, refer to Specifications Battery and Charging System