Seat Occupant Classification Module - Air Bag: Service and Repair

Occupant Classification Sensor

Removal

WARNING: Persons working on the supplemental restraint system (SRS) must be fully trained and have been issued with the safety guidelines.

WARNING: Allow a period of 10 minutes to elapse after disconnecting the battery before undertaking any work on the SRS.

WARNING: The SRS electrical connectors are unique. DO NOT force, or attempt to connect electrical connectors to the wrong sockets.

WARNING: The correct procedures must always be used when working on SRS components.

WARNING: It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.

WARNING: Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.

WARNING: Take extra care when handling SRS components.

CAUTION: The front passenger seat occupant classification sensor is available only as a service kit. No attempt should be made to replace individual components. Failure to follow this instruction may result in personal injury.
1 Disconnect the battery ground cable. For additional information, refer to Specifications Battery and Charging System
2 Make the air bag supplemental restraint system (SRS) safe. For additional information, refer to Standard Workshop Practices Standard Workshop Practices
3 Remove the front seat cushion cover. For additional information, refer to Front Seat Cushion Cover Front Seat Cushion Cover




4 Disconnect the occupant classification sensor electrical connector.
- Release the 2 clips from the occupant classification sensor wiring harness.




5 Remove the occupant classification sensor.
- Remove the 2 clips.
- Reposition the occupant classification sensor wiring harness.

Installation
1 Install the occupant classification sensor.
- Reposition the occupant classification sensor wiring harness.
- Install the 2 clips.
2 Connect the occupant classification sensor electrical connector.
- Secure the 2 clips to the occupant classification sensor wiring harness.
3 Install the front seat cushion cover. For additional information, refer to Front Seat Cushion Cover Front Seat Cushion Cover
4 Connect the battery ground cable. For additional information, refer to Specifications Battery and Charging System
5 Using the Land Rover approved diagnostic system, calibrate the occupant classification sensor.