Rear Wheel Speed Sensor

Rear Wheel Speed Sensor

Removal

NOTE:
Removal steps in this procedure may contain installation details.
1 Disconnect the battery ground cable.For additional information, refer to Specifications Battery and Charging System
2
WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
3 For additional information, refer to Rear Fender Splash Shield Service and Repair

5
CAUTION: Before disconnecting or removing the components, ensure the area around the joint faces and connections are clean and dry. Plug open connections to prevent contamination.

6
NOTE:
Left hand shown, right hand similar.

7
CAUTION: Make sure that the component is clean, free of foreign material and lubricant.
CAUTION: Make sure that the mating faces are clean and free of foreign material.
CAUTION: Make sure that the sensor tip is clean and free of foreign material.
NOTE:
Left hand shown, right hand similar.

- TORQUE: 8 Nm

Installation
1 To install, reverse the removal procedure.
2 Configure the anti-lock brake system (ABS) module using the diagnostic tool.