Brake Light Switch: Service and Repair

Stoplamp Switch

Removal

CAUTION: The brake pedal MUST NOT be depressed during this operation. Failure to comply will result in damage to the stoplamp switch.




1 Remove the closing trim panel.
- Release the clip.
- Remove the 2 screws.
- Disconnect the electrical connector.




2 Remove the stoplamp switch.
- Disconnect the electrical connector.
- Rotate the switch clockwise.

Installation
1
CAUTION: The brake pedal MUST NOT be depressed during this operation. Failure to comply will result in damage to the stoplamp switch.
Install the stoplamp switch.
- Rotate the switch counterclockwise.
- Connect the electrical connector.
2 Install the closing trim panel.
- Connect the electrical connector.
- Secure the clip.
- Tighten the screws.