Engine Wiring Harness

Engine Wiring Harness
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures

Removal

NOTE:
Removal steps in this procedure may contain installation details.

NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.

All vehicles
For additional information, refer to Specifications Battery and Charging System

WARNING: Make sure to support the vehicle with axle stands.
1 Raise and support the vehicle.
2 Secure the hood in the service position.
For additional information, refer to Air Cleaner Outlet Pipe LH Air Cleaner Outlet Pipe LH
For additional information, refer to Air Cleaner Outlet Pipe RH Air Cleaner Outlet Pipe RH
For additional information, refer to Plenum Chamber Service and Repair
For additional information, refer to Exhaust System Service and Repair





NOTE:
Remove and discard the gasket.

Torque to: 48 Nm





NOTE:
Remove and discard the gasket.

Torque to: 48 Nm









WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable vapors are always present and may ignite. Failure to follow these instructions may result in personal injury.

CAUTION: Be prepared to collect escaping fuel.





NOTE:
RHD illustration shown, LHD is similar.













NOTE:
Make sure the electrical connector is correctly secured.

















Torque to: 10 Nm

























Torque to: 10 Nm













Torque to: 6 Nm









Torque to: 10 Nm

All vehicles





NOTE:
RHD illustration shown, LHD is similar.

Torque to: 47 Nm





NOTE:
RHD illustration shown, LHD is similar.

Torque to: 47 Nm





















Torque to: 48 Nm








M8: 10 Nm
M6: 4 Nm













Torque to: 10 Nm





Torque to: 10 Nm





Torque to: 10 Nm





Torque to: 10 Nm









NOTE:
RHD illustration shown, LHD is similar.

Installation

NOTE:
After the engine harness has been installed, test using Land Rover/ Jaguar approved diagnostic equipment.
1 To install, reverse the removal procedure.