Air Dryer: Service and Repair

Air Suspension Compressor Drier

Removal

CAUTION: If a new air suspension compressor, air compressor drier or air compressor delivery valve kit is installed due to failure, an air compressor relay must be installed. Failure to follow this instruction may result in damage to the air suspension system components.

NOTE:
Removal steps in this procedure may contain installation details.
1 Disconnect the battery ground cable. For additional information, refer to Specifications Battery and Charging System
2 Remove the air suspension compressor. For additional information, refer to Air Suspension Compressor Service and Repair




3
CAUTION: Before disconnecting or removing the components, ensure the area around the joint faces and connections are clean and dry. Plug open connections to prevent contamination.
CAUTION: Visually inspect the air line ends for damage or wear. Replace the air line as necessary.
NOTE:
Remove and discard the O-ring seal.

- TORQUE: 3 Nm
Lubricate the O-ring with a lithium based grease.

Installation
1 To install, reverse the removal procedure.