Compressor/Pump: Service and Repair

Air Suspension Compressor

Removal

CAUTION: If a new air suspension compressor, air compressor drier or air compressor delivery valve kit is installed due to failure, an air compressor relay must be installed. Failure to follow this instruction may result in damage to the air suspension system components.

NOTE:
Removal steps in this procedure may contain installation details.

NOTE:
Lower the suspension ride height to access level, using the ride height control switches.
1 Disconnect the battery ground cable. For additional information, refer to Specifications Battery and Charging System
2 For additional information, refer to Air Suspension System Depressurize and Pressurize Service and Repair




3 Remove the spare wheel and tire.




4
- TORQUE: 10 Nm




5
CAUTION: Before disconnecting or removing the components, ensure the area around the joint faces and connections are clean and dry. Plug open connections to prevent contamination.





6
CAUTION: Before disconnecting or removing the components, ensure the area around the joint faces and connections are clean and dry. Plug open connections to prevent contamination.
CAUTION: Visually inspect the air line ends for damage or wear. Replace the air line as necessary.





7
- TORQUE: 10 Nm




8
NOTE:
Do not disassemble further if the component is removed for access only.
NOTE:
Note the fitted position of the washers.





9
CAUTION: Visually inspect the air line ends for damage or wear. Replace the air line as necessary.

- TORQUE: 10 Nm





10 Remove the air suspension compressor.
- TORQUE: 10 Nm

Installation
1 To install, reverse the removal procedure.