Suspension Control Module: Service and Repair

Air Suspension Control Module

Removal

NOTE:
Removal steps in this procedure may contain installation details.
1 Disconnect the battery ground cable. For additional information, refer to Specifications Battery and Charging System

3
CAUTION: Take extra care not to damage the wiring harnesses.

- TORQUE: 8 Nm

4
CAUTION: Before disconnecting or removing the components, make sure the area around the joint faces and connections are clean.

- TORQUE: 9 Nm

Installation
1 To install, reverse the removal procedure.
2
CAUTION: Calibration of the air suspension system must be carried out after the following components have been replaced: air suspension control module, suspension height sensor, suspension components and body panels incorporating suspension fixing points.
Configure the air suspension control module using the diagnostic tool.