Body - Door Mirror Wind Noise
TECHNICAL BULLETINLTB00419NAS3
23 MAY 2012
ISSUE '3' CHANGES ARE HIGHLIGHTED IN GRAY
SECTION: 501
Door Mirror Wind Noise
AFFECTED VEHICLE RANGE:
Range Rover (LM)
VIN: AA304426 - *CA383407*
Model Year: 2010 - 2012
CONDITION SUMMARY:
Situation:
A wind noise may be heard from the left or right front door mirror(s). This may be caused by air penetration between the mirror and the door mating surface Action: In the event of a customer concern of the above, refer to the Repair Procedure outlined below to insert a Nitto foam pad at the door mirror mounting area.
PARTS:
NOTE:
The Nitto foam should be locally sourced from the Squeaks & Rattles Kit and must be claimed as 'sublet' using code 'other' (up to $3.09).
Nitto foam - locally sourced from the Squeaks & Rattles Kit
TOOLS:
Refer to Workshop Manual for any required special tools
WARRANTY:
NOTE:
Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only. Always refer to DDW to obtain the latest repair time.
NOTE:
The Nitto foam should be locally sourced from the Squeaks & Rattles Kit and must be claimed as 'sublet' using code 'other' (up to $3.09).
DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.
Normal Warranty policies and procedures apply
REPAIR PROCEDURE
INSTALL NITTO FOAM PAD TO MIRROR MOUNTING AREA
1. Refer to Workshop Manual, section 501-09: Rear View Mirrors, and remove the door mirror.
2. Identify the cavity.
3. Identify the area to be covered by the Nitto foam.
CAUTION:
Make sure that the pad does not interfere with the mirror assembly.
4. Install the pad.
^ Cut the locally sourced Nitto foam from the Squeaks & Rattles Kit into a 25mm X 15mm rectangle.
^ Install in to the location shown.
5. Refer to Workshop Manual, section 501-09: Rear View Mirrors, and install the door mirror.
6. If necessary, repeat steps 1 - 5 to the opposite door / mirror.
Disclaimer