Component Tests and General Diagnostics

1. INSPECT COMBINATION METER WIRING CIRCUIT
Disconnect connectors A, B and C from the combination meter and inspect the connectors on the wire harness side as follows.





Ground

ECU-B Fuse

GAUGE Fuse

Brake Warning Switch

Buckle Switch

Center Diff. Lock Indicator Switch

Engine Oil Level Warning Switch

Generator "L" Terminal

Turn Signal Switch and Hazard Warning Switch

Headlight

Transfer Neutral Position Switch

Front Diff. Lock Position Switch

Rear Diff. Lock Position Switch

Fuel Sender Gauge

IGN Fuse

Door Courtesy Switch

DOOM Fuse

Park/Neutral Position Switch

If circuit is not as specified, refer to the wiring diagram and inspect the circuit connected to other parts.