Installation

^ Never use SRS parts from another vehicle. When replacing parts, replace with new parts.
^ Never reuse the airbag sensor assembly involved in a collision when the airbag has deployed.
^ Never repair a sensor in order to reuse it.

1. INSTALL AIRBAG SENSOR ASSEMBLY
a. Using a torx wrench, install the airbag sensor assembly with the 4 screws.
Torx wrench: T40 (Part No. 09042-00020 or locally manufactured tool)
Torque: 21 N.m (210 kgf.cm, 15 ft.lbf)
b. Connect the connector.

NOTICE:
^ Installation of the connector is done with the sensor assembly installed.
^ Make sure the sensor assembly is installed to the specified torque.
^ If the sensor assembly has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor assembly with a new one.
^ When installing the sensor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other parts.
^ After installation, shake the sensor assembly to check that there is no looseness.

2. INSTALL THE REMOVED PARTS