Component Tests and General Diagnostics

INSPECT INDICATOR LIGHT OPERATION
Connect the positive (+) lead from the battery to terminal 5 and the negative (-) lead to terminal 6, and check that the indicator light does not light up, replace the switch.

w/ Driving Position Memory only:
INSPECT MIRROR POSITION SENSORS OPERATION

HINT: Strip off the vinyl tape of the connector and remove terminals 6, 7, 9, 10, 15 and 16 from the connector housing.




a. Connect a series of three 1.5 V dry cell batteries.
b. Connect the positive (+) lead from the dry cell batteries to terminal 9 and the negative (-) lead to terminal 15.
c. Connect the positive (+) lead from the voltmeter to terminal 16 and the negative (-) lead to terminal 15.







d. Apply battery positive voltage to terminals 7 and 6, then check that the voltage gradually changes according to the table while the mirror moves between the uppermost position and lowermost position.
If voltage value is not as specified, replace the motor assembly.




e. Disconnect the 4 leads of the battery and voltmeter.
f. Connect the positive (+) lead from the voltmeter to terminal 10 and negative (-) lead to terminal 15.







g. Apply battery positive voltage to terminals 6 and 7, then inspect that the voltage gradually changes according to the table while the mirror moves between the left most position and right-most position.
If voltage value is not as specified, replace the motor assembly.