B. Removal

1. Remove the four corner Support Covers by grasping with two hands and lifting vertically. You may have to give them a tug, but the Covers will come off. Your hands need to be clean to get a good grip on the Covers. Do not use tools to try to pry the Covers off as the finish may be damaged.





2. Each of the four Corner Supports is bolted to the roof with two bolts each. These can be removed with a T30 Torx bit. Remove all eight bolts.

3. Slide each Side Rail forward approximately 6 - 10 mm to release them from the Center Supports. Remove the Rack Assembly and place it upside down on a work table protected with clean shop rags.





4. Using a T15 Torx bit, remove the Screws that hold the Rear Supports to the Side Rails. After the Rear Supports are removed, the Cross Bars may be removed and turned around as shown in this sketch.