Ignition Timing: Testing and Inspection
INSPECTION1. REMOVE V-BANK COVER
a. Using a 5 mm hexagon wrench, remove the 3 nuts.
b. Remove the V-bank cover fastener clip and V-bank cover.
2. WARM UP ENGINE
Allow the engine to warm up to normal operating temperature.
3. CONNECT LEXUS HAND-HELD TESTER OR OBDII SCAN TOOL
a. Connect the LEXUS hand-held tester or OBDII scan tool to the DLC3.
b. Please refer to the LEXUS hand-held tester or OBDII scan tool operator's manual for further details.
4. CONNECT TIMING LIGHT TO ENGINE
Connect the tester probe of a timing light to the lead wire as shown.
5. CHECK IDLE SPEED
a. Race the engine speed at 2,500 rpm for approx. 90 seconds.
b. Check the idle speed.
Idle speed: 700 ± 50 rpm
6. INSPECT IGNITION TIMING
a. Using Special Service Tool (SST), connect terminals TE1 and E1 of the DLC1.
SST 09843-18020
b. Using a timing light, check the ignition timing.
Ignition timing: 8 - 12° BTDC @ idle (Transmission in neutral position)
c. Remove the SST from the DLC1.
SST 09843-18020
7. FURTHER CHECK IGNITION TIMING
Ignition timing: 10 - 25° BTDC @ idle (Transmission in neutral position)
HINT: The timing mark moves in a range between 10° and 25°.
8. DISCONNECT TIMING LIGHT FROM ENGINE
9. DISCONNECT LEXUS HAND-HELD TESTER OR OBDII SCAN TOOL
10. REINSTALL V-BANK COVER