Removal

NOTE:
If the wiring connector of the SRS is disconnected and the ignition switch is in ON or ACC position, DTCs will be recorded.
Never use the airbag parts from another vehicle. When replacing parts, replace them with new parts.






1. DISCONNECT AIRBAG CONNECTOR
a. Using a screwdriver, pry out the glove compartment door finish plate inside the lower No.2 panel.

HINT: Tape the screwdriver tip before use.

b. Remove the connector from the glove compartment door finish plate.
c. Disconnect the airbag connector.

NOTE: When disconnecting the airbag connector, take care not to damage the airbag wire harness.

2. REMOVE LOWER NO.2 PANEL
a. Remove the front door scuff plate RH and cowl side trim RH.
b. Remove the No.2 under cover.
c. Remove the 2 bolts, 2 screws and lower No.2 panel.
d. W/CD changer:
Remove the 4 nuts and CD changer.






3. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY
a. Remove the 2 bolts and 2 nuts.
b. Remove the front passenger airbag assembly from the instrument panel.

CAUTION:
- Do not store the front passenger airbag assembly with the airbag deployment side facing down.
- Never disassemble the front passenger airbag assembly.