Removal

NOTE:
- If the wiring connector of the SRS is disconnected with the ignition switch at ON or ACC position, DTCs will be recorded.
- Never use SRS parts from another vehicle. When replacing parts, replace them with new parts.
- Never reuse the sensor involved in a collision when the SRS has deployed.
- Never repair a sensor in order to reuse it.





1. LH:
REMOVE FRONT AIRBAG SENSOR
a. Remove the hold-down clamp, battery and battery tray.
b. Disconnect the front airbag sensor connector.

NOTE: Disconnect the connector with sensor assembly installed.

c. Remove the 2 nuts and remove the front airbag sensor.

2. RH:
REMOVE FRONT AIRBAG SENSOR
a. Disconnect the front airbag sensor connector.

NOTE: Disconnect the connector with sensor assembly installed.




b. Remove the 2 nuts and remove the front airbag sensor.