Programming and Relearning
GARAGE DOOR OPENER SYSTEMREGISTRATION PROCEDURE
1. NEW CODE REGISTRATION
NOTE:
- If using the original transmitter to register the code, the system might operate.
- When registering the transmitter codes such as for garage or gate, check that there is nobody around those places.
a. Press the switch for the item to be registered for 20 Seconds
HINT: When transferring to registration mode, LED (red) blinks in 1 Hz cycle.
b. In the condition of (a), bring the original transmitter to within 1-inch area around the garage door opener and press the switch. (code transmitting).
HINT: When code registration is completed correctly, LED (red) blinks in 5.6 Hz cycle.
New code registration timing chart
If a code can not be registered, observe the following conditions.
HINT:
- If the battery of original transmitter is consumed.
- Press the switch of original transmitter repeatedly in registration mode as some transmitters stop transmitting for 1 to 2 seconds.
- This system is not applicable to the garage door opener which had been made before 1982.
2. CODE DELETION
a. Press the switches at both ends of garage door opener simultaneously for 20 seconds.
HINT: When transferring to deletion mode, LED (red) blinks in 6 Hz cycle.
b. When releasing the switch within 10 seconds after transferring to deletion mode, all the registered codes will be erased
HINT: Press the switch until it blinks in 6 Hz cycle stops so that the default code for check is set.
Code deletion timing chart