Cylinder Head

SERVICE SPECIFICATIONS
Cylinder Head:
Warpage:
Maximum 0.10 mm (0.039 inch)
Bolt Thread Inside Diameter:
Standard 9.810 - 9.960 mm (0.3862 - 0.3921 inch)
Minimum 9.70 mm (0.3819 inch)
Lifter Bore Diameter 31.000 - 31.016 mm (1.2205 - 1.2211 inch)
Oil Clearance:
Standard 0.024 - 0.050 mm (0.0009 - 0.0020 inch)
Maximum 0.07 mm (0.0028 inch)

TORQUE SPECIFICATIONS
Cylinder Head To Cylinder Block:
1st Turn 32 Nm ( 326 kgf-cm 24 ft. lbs.)
2nd Turn 90°
3rd Turn 90°
Camshaft Bearing Cap To Cylinder Head:
Bolt C 7.5 Nm (66 inch lbs.)
Others 16 Nm (12 ft. lbs.)
Engine Hanger To Cylinder Head 37 Nm ( 27 ft. lbs.)
Front Water Bypass Joint, Rear Water Bypass Joint To:
Cylinder Head 18 Nm (13 ft. lbs.)
Timing Belt Rear Plate To:
Cylinder Head 7.5 Nm (66 inch lbs.)