For Vehicle Equipped With Vehicle Skid Control (Vsc) System

FOR VEHICLE EQUIPPED WITH VEHICLE SKID CONTROL (VSC) SYSTEM




a. Precaution when using drum tester:
When using a drum tester, make sure that the ignition switch is OFF, start the engine with the diagnosis connector short-circuited between Ts and E1 (CG) and take a measurement.

NOTE:
- Check that VSC warning light is blinking.
- Ensure that the vehicle does not move using wires.
- After the measurement, disconnect the short circuit and check that the VSC warning light is turned off when restarting the engine.

b. Precaution during VSC operation:
1. Since VSC may be affected by the removal/installation of the VSC-related parts, do not remove/install those parts unless absolutely necessary.
2. When operating on VSC, follow the instructions in Antilock Brakes/Traction Control Systems to surely make preparations or check after operations.