Rear

REMOVAL
1. REMOVE REAR WHEEL
Torque: 131 Nm (1,340 kgf-cm, 97 ft. lbs.)
2. SUPPORT REAR AXLE HOUSING WITH JACK





3. LH Side:
DISCONNECT HEIGHT CONTROL SENSOR LINK
a. Place matchmarks on the height control sensor link and upper control arm.
b. Remove the nut and disconnect the height control sensor link.
Torque: 5.6 Nm (57 kgf-cm, 49 inch lbs.)





4. REMOVE UPPER CONTROL ARM
a. Disconnect the ABS speed sensor wire harness.
b. RH side:
Remove the bolt from the heat insulator.
Torque: 18 Nm (185 kgf-cm, 13 ft. lbs.)
c. Remove the 2 nuts, washers, bolts, and upper control arm.
Torque: 150 Nm (1,530 kgf-cm, 111 ft. lbs.)

HINT: At the time of installation, please refer to the following items.
^ Replace the used 2 nuts with new ones.
^ After stabilizing the suspension, torque the nuts.





5. REMOVE LOWER CONTROL ARM
Remove the 2 nuts, washers, bolts and lower control arm.
Torque: 150 Nm (1,530 kgf-cm, 111 ft. lbs.)

HINT: At the time of installation, please refer to the following items.
^ Replace the used 2 nuts with new ones.
^ After stabilizing the suspension, torque the nuts.

INSTALLATION
Installation is in the reverse order of removal.