Rear Wiper and Washer
REMOVAL1. REMOVE REAR WIPER ARM
a. Open the cover.
b. Remove the nut and the rear wiper arm.
c. Remove the grommet.
2. REMOVE ASSIST GRIP
a. Using a screwdriver, remove the 2 assist grip plugs.
HINT: Tape up the the screwdriver tip before use.
b. Remove the 2 screws and the assist grip.
3. REMOVE INSIDE HANDLE BEZEL
4. REMOVE CENTER BACK DOOR GARNISH
Using a screwdriver, remove the center back door garnish.
HINT: Tape up the screwdriver tip before use.
5. REMOVE BACK DOOR GARNISH
Using a screwdriver, remove the back door garnish.
HINT: Tape up the screwdriver tip before use.
6. REMOVE REAR WIPER MOTOR AND LINK ASSEMBLY
a. Disconnect the connector.
b. Remove the 2 bolts.
c. Unfasten the 3 bolts, and remove the rear wiper motor with the link assembly.
INSTALLATION
1. INSTALL REAR WIPER MOTOR AND LINK ASSEMBLY
a. Install the wiper motor and the link assembly with the 5 bolts.
Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)
b. Connect the connector.
2. INSTALL BACK DOOR GARNISH
3. INSTALL CENTER BACK DOOR GARNISH
4. INSTALL INSIDE HANDLE BEZEL
5. INSTALL ASSIST GRIP
Install the assist grip with the 2 screws, then install the 2 assist grip plugs.
6. INSTALL REAR WIPER ARM
a. Install the grommet.
b. Operate the wiper once, and turn the wiper switch OFF.
c. Install the wiper arm, and tighten the nut by hand.
d. Adjust the installation position of the wiper arm to the position as shown in the illustration.
A: Approx. 38 ± 10 mm (1.50 ± 0.39 in.)
e. Torque the nut.
Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)
f. Close the cover.