Rear Seat (RH)
REMOVALREMOVE REAR SEAT
a. Using a screwdriver, remove the front part of deck board assembly.
HINT: Tape the screwdriver tip before use.
b. Remove the 4 clips.
c. Using a screwdriver, remove the seat track covers.
HINT: Tape the screwdriver tip before use.
d. Remove the 4 bolts.
e. Remove the rear seat.
NOTE: Be careful not to damage the body.
INSTALLATION
INSTALL REAR SEAT
a. Slide the rear seat to the front most position.
NOTE: Make sure that seat adjuster locks.
b. Without holding the seat track handle, mount the seat to the vehicle.
HINT: If holding the seat track handle, the adjusted front most positions slip off.
c. Tighten the bolts on the rear side temporarily, from the bolt on the inner side tighten them completely.
Torque: 37 N.m (375 kgf.cm, 27 ft.lbf)
d. Slide the seat to the rear most position to install the bolts on the front side.
Torque: 37 N.m (375 kgf.cm, 27 ft.lbf)
e. Install the seat track covers.
f. Install the 4 clips.
g. Install the front part of the deck board assembly.