Component Tests and General Diagnostics

INSPECTION







1. INSPECT LIGHT CONTROL SWITCH CONTINUITY
If continuity is not as specified, replace the switch.







2. INSPECT HEADLIGHT DIMMER SWITCH CONTINUITY
If continuity is not as specified, replace the switch.




3. INSPECT COMBINATION SWITCH CIRCUIT
Connect the wire harness side connector to the combination switch and inspect wire harness side connector from the back side.




Light Control Switch:




Headlight Dimmer Switch:
If the circuit is not as specified, inspect the circuit connected to other parts.







4. INSPECT HEADLIGHT CONTROL RELAY CONTINUITY
If continuity is not as specified, replace the relay.

5. INSPECT HEADLIGHT CONTROL RELAY CIRCUIT







6. INSPECT TAILLIGHT CONTROL RELAY CONTINUITY
If continuity is not as specified, replace the relay.

7. INSPECT TAILLIGHT CONTROL RELAY CIRCUIT







8. INSPECT DRL NO.3 RELAY CONTINUITY
If continuity is not as specified, replace the relay.

9. INSPECT DRL NO.3 RELAY CIRCUIT







10. INSPECT DRL NO.2 AND NO.4 RELAY CONTINUITY
If continuity is not as specified, replace the relay.

11. INSPECT DRL N02 AND NO.4 RELAY CIRCUIT
12. INSPECT LIGHT AUTO TURN OFF SYSTEM (See Integration relay circuit).




13. Auto ON:
INSPECT AUTOMATIC LIGHT CONTROL
a. Turn the ignition switch ON.
b. Turn the light control switch to AUTO.
c. Gradually cover the top of the sensor.
d. Verity that the accessory lights and the headlights turn ON.




14. Auto OFF:
INSPECT AUTOMATIC LIGHT CONTROL
a. Gradually expose the sensor.
b. Verify that the headlights and the accessory lights turn OFF.

15. INSPECT LIGHT-OFF CONDITION
a. Turn the ignition switch ON.
b. Lights auto ON:
Gradually cover the top of the sensor.
c. Verify that the lights will go out when light control switch position is OFF or the area surrounding the sensor gets bright or open the driver's door while the ignition switch is OFF.

16. INSPECT LIGHTS-ON CONDITION
a. Open the driver's door while the ignition switch is OFF.
b. Turn the light control switch to AUTO leaving the door open and cover the top of the sensor, and verify that the lights go on when the ignition switch is turned ON.




17. Connector disconnected:
INSPECT AUTOMATIC LIGHT CONTROL SENSOR CIRCUIT
Disconnect the connector from the sensor and inspect the connector on the wire harness side, as shown in the chart.
If circuit is as specified, perform the inspection.
If the circuit is not as specified, inspect the circuit connected to other parts.







18. Connector connected:
INSPECT AUTOMATIC LIGHT CONTROL SENSOR CIRCUIT
Connect the wire harness side connector to the sensor and inspect wire harness side connector from the back side, as shown.

HINT:
- Ignition switch ON.
- Light control switch OFF.

Vehicle's surroundings are bright.
If circuit is as specified, try replacing the sensor with a new one. If the circuit is not as specified, inspect the circuit connected to other parts.