Disassembly and Assembly

DISASSEMBLY
1. REMOVE AXLE HUB AND INNER RACE (INSIDE)





a. Using SST, remove the axle hub from the axle carrier.
SST 09520-00031
b. Remove the inner race (inside).





c. Using SST, and a press, remove the inner race (outside) from the axle hub.
SST 0955-55010, 09950-0010 (09951-0360), 0995-70010 (09951-7100)
2. REMOVE BACKING PLATE
Remove the 4 nuts and backing plate.





3. REMOVE INNER AND OUTER OIL SEALS
Using SST, remove the inner and outer oil seals.
SST 09308-00010
4. REMOVE SNAP RING
Using snap ring pliers, remove the snap ring.





5. REMOVE BEARING FROM REAR AXLE CARRIER
a. Place the inner race on the inside of the bearing.
b. Using SST and a press, remove the bearing from the axle carrier.
SST 09310-35010

REASSEMBLY





1. INSTALL BEARING
Using SST and a press, install the bearing to the axle carrier.
SST 09527-17011, 09950-0020 (09951-00710), 09950-70010 (09951-07100)

NOTICE: If the inner race and balls become loose and come out from the bearing outer race, make sure to Install them on the same side as before.

2. INSTALL SNAP RING
Using snap ring pliers, install a new snap ring.





3. INSTALL OUTER OIL SEAL
a. Using SST and a hammer, install a new outer oil seal.
SST 09608-32010, 09950-70010 (09951-07100)
b. Coat MP grease to the oil seal lip.
4. INSTALL BACKING PLATE
Install the backing plate with the 4 nuts.
Torque: 72 Nm (730 kgf-cm, 53 ft. lbs.)





5. INSTALL AXLE HUB
Using SST and a press, install the axle hub.
SST 09950-60020 (09951-00730), 09950-70010 (09951-07100)

NOTICE: Be careful not to damage the bearing.





6. INSTALL INNER OIL SEAL
a. Using SST and a hammer, install a new inner oil seal.
SST 09316-60011 (09316-00011, 09316-00031), 09502-12010
b. Coat MP grease to the oil seal lip.