Kinetic Dynamic Suspension System

STABILIZER CONTROL ECU (KDSS - Kinetic Dynamic Suspension System)
REPLACEMENT


1. DISCONNECT BATTERY NEGATIVE TERMINAL
2. REMOVE ROOF SIDE GARNISH INNER LH

HINT: Refer to the procedures up to "REMOVE ROOF SIDE GARNISH INNER LH".





3. REMOVE STABILIZER CONTROL ECU
a. Disconnect the connector.
b. Remove the 2 bolts and stabilizer control ECU.

NOTICE:
^ Avoid any impact to the stabilizer control ECU.
^ Replace the stabilizer control ECU with a new one if it is dropped.





4. INSTALL STABILIZER CONTROL ECU
a. Install the stabilizer control ECU with the 2 bolts.
Torque: 7.8 Nm (80 kgf-cm, 69 inch lbs.)
b. Connect the connector.
5. INSTALL ROOF SIDE GARNISH INNER LH

HINT: Refer to the procedures from "INSTALL ROOF SIDE GARNISH INNER LH".

6. CONNECT BATTERY NEGATIVE TERMINAL
7. PERFORM ACCELERATION SENSOR ASSEMBLY ZERO POINT CALIBRATION
Refer to Suspension Control ( Automatic - Electronic Level ); Testing and Inspection.