Rear Right Sensor

Air Bag Sensor Rear RH:

REPLACEMENT

1. PRECAUTION
Refer to Air Bag Systems; Service Precautions.
2. DISCONNECT BATTERY NEGATIVE TERMINAL
3. REMOVE QUARTER SCUFF PLATE INNER RH
4. REMOVE REAR DOOR SCUFF PLATE RH
5. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH
6. REMOVE REAR FLOOR MAT SUPPORT PLATE REAR
7. REMOVE BACK DOOR WEATHERSTRIP
8. REMOVE REAR NO. 2 SEAT ASSEMBLY RH
9. REMOVE LAP BELT OUTER ANCHOR COVER REAR NO.1 SEAT
10. REMOVE REAR NO.2 SEAT BELT ASSEMBLY OUTER RH
11. REMOVE QUARTER INSIDE TRIM BOARD RH




12. REMOVE AIR BAG SENSOR REAR RH
a. Disconnect the connector of the airbag sensor rear RH.
b. Remove the 2 nuts and the airbag sensor rear RH.




13. INSTALL AIR BAG SENSOR REAR RH
a. Install the airbag sensor rear RH with the 2 nuts.

Torque: 17.5 N.m (178 kgf.cm, 13 ft.lbf)

b. Connect the connector of the airbag sensor rear RH.

NOTE:
- Installation of the connector is done with the sensor assembly installed. Make sure the sensor assembly is installed with the specified torque.
- If the sensor assembly has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor assembly with a new one.
- When installing the sensor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other parts.
- After installation, shake the sensor assembly to check that there is no looseness.

14. INSPECT AIR BAG SENSOR REAR RH
15. INSTALL REAR NO.2 SEAT BELT ASSEMBLY OUTER RH
16. INSPECT SRS WARNING LIGHT