Seat Position Air Bag Sensor

Seat Position Air Bag Sensor:

REPLACEMENT

1. PRECAUTION
Refer to Air Bag Systems; Service Precautions.
2. SEPARATE BATTERY NEGATIVE TERMINAL
3. REMOVE SEAT TRACK BRACKET COVER OUTER FRONT LH
4. REMOVE SEAT TRACK BRACKET COVER INNER FRONT LH
5. REMOVE SEAT TRACK COVER RH
6. REMOVE SEAT TRACK COVER RH
7. REMOVE FRONT SEAT ASSEMBLY LH




8. REMOVE SEAT POSITION AIR BAG SENSOR
a. Disconnect the connector of the seat position airbag sensor.
b. Remove the bolt and seat position airbag sensor.




9. INSTALL SEAT POSITION AIR BAG SENSOR
a. Install the seat position airbag sensor with a new bolt.

Part No.:
Bolt: 90119-06871

Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)

b. Connect the connector of the seat position airbag sensor.

NOTE:
- Installation of the connector is done with the sensor assembly installed. Make sure the sensor assembly is installed with the specified torque.
- If the sensor assembly has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor assembly with a new one.
- When installing the sensor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other parts.
- After installation, shake the sensor assembly to check that there is no looseness.

10. INSTALL FRONT SEAT ASSEMBLY LH
11. INSPECT SRS WARNING LIGHT