Side Sensor

Side Air Bag Sensor Assy RH:

REPLACEMENT

1. PRECAUTION
Refer to Air Bag Systems; Service Precautions.
2. DISCONNECT BATTERY NEGATIVE TERMINAL
3. REMOVE QUARTER SCUFF PLATE INNER RH
4. REMOVE FRONT DOOR SCUFF PLATE RH
5. REMOVE QUARTER SCUFF PLATE INNER RH
6. REMOVE REAR DOOR SCUFF PLATE RH
7. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH
8. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH
9. REMOVE LAP BELT OUTER ANCHOR COVER
10. REMOVE CENTER PILLAR GARNISH LOWER RH
11. REMOVE FRONT SEAT OUTER BELT ASSEMBLY RH




12. REMOVE SIDE AIR BAG SENSOR ASSEMBLY RH
a. Remove the 2 nuts and side airbag sensor assembly RH.
b. Disconnect the connector from the side airbag sensor assembly RH.

13. INSPECT SIDE AIR BAG SENSOR ASSEMBLY RH




14. INSTALL SIDE AIR BAG SENSOR ASSEMBLY RH
a. Connect the side airbag sensor assembly RH connector.
b. Install the side airbag sensor assembly RH with the 2 nuts.

Torque: 17.5 N.m (178 kgf.cm, 13 ft.lbf)

NOTE:
- Installation of the connector is done with the sensor assembly installed. Make sure the sensor assembly is installed with the specified torque.
- If the sensor assembly has been dropped, or there are cracks, dents or other detects in the case, bracket or connector, replace the sensor assembly with a new one.
- When installing the sensor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other parts.
- After installation, shake the sensor assembly to check that there is no loosen

15. INSTALL FRONT SEAT OUTER BELT ASSEMBLY RH

Torque:
Upper bolt: 7.5 N.m (76 kgf.cm, 66 in.lbf)
Lower bolt: 42 N.m (430 kgf.cm, 31 ft.lbf)

16. INSPECT SRS WARNING LIGHT