Safing Sensor: Service and Repair

Air Bag Sensor Assy Center:

AIR BAG SENSOR ASSEMBLY CENTER

REPLACEMENT

1. PRECAUTION
Refer to Air Bag Systems; Service Precautions.
2. DISCONNECT BATTERY NEGATIVE TERMINAL
3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
4. REMOVE CONSOLE UPPER PANEL GARNISH NO.2
5. REMOVE CONSOLE UPPER PANEL GARNISH NO.1
6. REMOVE CONSOLE PANEL UPPER ASSEMBLY
7. REMOVE CONSOLE REAR END PANEL SUB-ASSEMBLY
8. REMOVE RR CONSOLE BOX ASSEMBLY
9. REMOVE CONSOLE BOX INSERT FRONT NO.2
10. REMOVE CONSOLE BOX INSERT
11. REMOVE CONSOLE UPPER PANEL GARNISH FRONT
12. REMOVE CONSOLE BOX LOWER




13. REMOVE AIR BAG SENSOR ASSEMBLY CENTER
a. Disconnect the 3 connectors from the airbag sensor assembly center.
b. Remove the 3 bolts and airbag sensor assembly center.

14. INSPECT AIR BAG SENSOR ASSEMBLY CENTER
Refer to Air Bag Systems; Testing and Inspection.




15. INSTALL AIR BAG SENSOR ASSEMBLY CENTER
a. Check that the ignition switch turn OFF.
b. Check that the battery negative (-) terminal is disconnected.

NOTE: Do not start the operation for 90 seconds after removing the terminal.

c. Temporarily install the airbag sensor assembly center with the 3 bolts.
d. Tighten the 3 bolts to the specified torque.

Torque: 17.5 N.m (178 kgf.cm, 13 ft.lbf)

e. Connect the connector to the airbag sensor assembly center.
f. Check that no play is identified.
g. Check that the water- proof sheet is properly set.

16. INSPECT SRS WARNING LIGHT