Ride Height Sensor: Service and Repair

HEIGHT CONTROL SENSOR SUB-ASSEMBLY REAR LH (With Electric Modulated Air Suspension)
REPLACEMENT
1. REMOVE REAR DISC WHEEL





2. REMOVE HEIGHT CONTROL SENSOR SUB-ASSEMBLY REAR LH
a. Disconnect the connector from the height control sensor.
b. Place matchmarks on the link and the bracket.
c. Remove the nut and disconnect the sensor link.
d. Remove the 2 bolts and height control sensor.
3. INSTALL HEIGHT CONTROL SENSOR SUB-ASSEMBLY REAR LH
a. Install the height control sensor with the 2 bolts.
Torque: 13 Nm (133 kgf-cm, 10 ft. lbs.)
b. Align the matchmarks on the link and the bracket.
c. Connect the sensor link with the nut.
Torque: 5.4 Nm (55 kgf-cm, 48 inch lbs.)
d. Connect the connector to the height control sensor.
4. INSTALL REAR DISC WHEEL
Torque: 112 Nm (1,140 kgf-cm, 83 ft. lbs.)
5. MEASURE VEHICLE HEIGHT
Refer to Alignment; Service and Repair.
6. ADJUST VEHICLE HEIGHT
Refer to Alignment; Service and Repair.