Without Scan Tool

Clear the DTCs.




1. Make sure the ignition switch is off.
2. Using SST, connect terminals TC and CG of the DLC3.
SST 09843-18040

3. Turn the ignition switch to the ON position.




4. Clear the DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.
5. Check that the KDSS indicator lamp blinks in the normal system code blinking pattern.

HINT: If the fault has not been repaired, the DTC code may still be displayed.

6. Turn the ignition switch off.
7. Remove the SST from the DLC3.
SST 09843-18040

HINT: Disconnecting the battery cable during the operation will not erase DTCs in the ECU.