ABS (Antilock Brake System)
DIAGNOSTIC TROUBLE CODE CHARTNOTICE: When removing parts, turn the ignition switch OFF.
HINT:
^ Using SST 09843-18040, connect terminals TC and CG of the DLC3.
^ If any abnormality is not found when inspecting parts, inspect the ECU and ground points for poor contact.
^ If a trouble code is displayed during the DTC check, check the circuit listed for that code.
^ When 2 or more DTCs are recorded and the problem is not identified, perform circuit inspection of the other DTCs.
DTC C0200-C1238:
DTC C1239-C1268:
HINT:
^ *1: As the DTC cannot be erased by replacing parts alone, do either of these operations.
1 Clear the DTC.
2 At a speed of 20 km/h (12 mph), drive the vehicle for 30 seconds or more.
^ *2: Using this table, troubled parts can be specified.
