Navigation System

DIAGNOSTIC TROUBLE CODE CHART

21-D8:

D9-E3:

10-11:

10-12:

a. Physical address: 110 multi-display (EMV)

HINT:
- *1: Even if no failure is detected, it may be stored depending on the battery condition or voltage for starting an engine.
- *2: It is stored when 180 seconds have passed after an the power supply connector is pulled out after engine start.
- *3: It may be stored when the key is turned again after an engine start.
- *4: It may be stored when the key is turned again 1 minute again after an engine start.

D4:

b. Physical address: 1C6 gateway ECU (G/W-ECU)

HINT: *When 210 seconds have passed after pulling out the power supply connector of the master component with the ignition switch in ACC or ON, this code is stored.

D6:

D8-DE:

DF-E4:

40:

c. Physical address: 190 radio receiver (AUDIO H/U)

HINT:
- *1: Even if no failure is detected, it may be stored depending on the battery condition or voltage for starting an engine.
- *2: It is stored when 180 seconds have passed after the power supply connector is pulled out after an engine start.
- *3: It may be stored when the key is turned again 1 minute after an engine start.
- *4: It may be stored when the key is turned again after an engine start.
- *5: When 210 sec. has passed after pulling out the power supply connector of the master component with the ignition switch in ACC or ON, this code is stored.

D6-E3:

10-44:

11-45:

d. Physical address: 178 navigation ECU (NAVI-ECU)

HINT:
- *1: Even if no failure is detected, it may be stored depending on the battery condition or voltage for starting an engine.
- *2: When 210 sec. has passed after pulling out the power supply connector of the master component with the ignition switch in ACC or ON, this code is stored.
- *3: It may be stored when the key is turned again 1 minute after an engine start.
- *4: It may be stored when the key is turned again after an engine start.

D6-E1:

E2-E3:

e. Physical address: 440 Stereo component amplifier

HINT:
- *1: Even if no failure is detected, it may be stored depending on the battery condition or voltage for starting engine.
- *2: It may be stored when the ignition switch is turned 1 min. again after start.
- *3: It may be stored when the ignition switch is again after engine start.
- *4: When 210 sec. has passed after pulling out the power supply connector of the master component with the ignition switch in ACC or ON, this code is stored.

21-D7:

DC-E4:

f. Physical address: 250 disc player changer (DVD-CH)

HINT:
- *1:Even if no failure is detected, it may be stored depending on the battery condition or voltage for starting an engine.
- *2:It may be stored when the key is turned again 1 minute after an engine start.
- *3:It may be stored when the key is turned again after an engine start.
- *4:When 210 seconds have passed after pulling out the power supply connector of the master component with the ignition switch in ACC or ON, this code is stored.