Without Scan Tool

SERVICE CHECK MODE (DTC CLEAR/RECHECK)

HINT: The illustrations may differ from the actual vehicle depending on the device settings and options.

a. Clear DTC




1. Press "Code CLR" switch for 3 seconds
2. Check result is cleared.

b. Recheck




1. Press the "Recheck" switch.




2. Confirm that all diagnostic codes are "OK" when the check results are displayed.

If a code other than "OK" is displayed, troubleshoot again.

3. Press "LAN Mon" to switch to "LAN Monitor" mode.




4. Confirm that all diagnostic codes are "No Err".

If a code other than "No Err" is displayed, troubleshoot again.