Engine Lubrication: Service and Repair

OIL FILTER

COMPONENTS:

REPLACEMENT

CAUTION:
^ Prolonged and repeated contact with mineral oil will result in the loss of natural oil from the skin, leading to dryness, irritation and dermatitis. In addition, used engine oil contains potentially harmful contaminants which may cause skin cancer.
^ Wear protective clothing and gloves. Avoid contact with used oil. If contact occurs, wash the area thoroughly with soap and waterless hand cleaner. Never use gasoline, thinners, or solvents to wash the skin.
^ In order to protect the environment, dispose of used oil and used oil filters at designated disposal sites only.

1. DRAIN ENGINE OIL
a. Remove the oil filler cap.





b. Remove the 2 bolts and No. 3 engine under cover.





c. Remove the oil drain plug and drain the oil into a container.
2. REMOVE OIL FILTER ASSEMBLY





a. Remove the 2 bolts and service hole cover.





b. Using SST, remove the oil filter.
SST 09228-07501
3. INSTALL OIL FILTER ASSEMBLY
a. Clean and check the oil filter installation surface.
b. Apply clean engine oil to the gasket of a new oil filter.





c. Lightly screw the oil filter into place by hand. Tighten it until the gasket contacts the seat.





d. Using SST, tighten the oil filter.
SST 09228-07501
1 Depending on the workspace available, choose accordingly. If enough space is available, use a torque wrench to tighten the oil filter.
Torque: 17.2 Nm (178 kgf-cm, 13 ft. lbs.)
If enough space is not available to use a torque wrench, tighten the oil filter a 3/4 turn by hand or with a common wrench.
4. ADD ENGINE OIL
a. Install a new gasket and the drain plug.
Torque: 39 Nm (398 kgf-cm, 29 ft. lbs.)
b. Add new oil.

Standard Oil Capacity:

c. Reinstall the oil filler cap.
5. CHECK FOR ENGINE OIL LEAKS
6. CHECK ENGINE OIL LEVEL





7. INSTALL NO. 3 ENGINE UNDER COVER
a. Install the engine undercover with the 2 bolts.





8. INSTALL SERVICE HOLE COVER
a. Install the service hole cover with the 2 bolts.