Operation CHARM: Car repair manuals for everyone.

Without Scan Tool

DTC CHECK / CLEAR





1. CHECK DTC (USING SST CHECK WIRE)
a. Using the SST, connect terminals 10 (TC) and 4 (CG) of DLC3.
SST 09843-18040





b. Turn the ignition switch ON.





c. Read and record any DTCs from the tire pressure warning light on the combination meter. Refer to the illustration on the left for examples of a normal system code and DTCs 13 and 33.

HINT: If the tire pressure warning light does not blink to indicate any DTCs or the normal system code, inspect the tire pressure warning light circuit or 10 (TC) and 4 (CG) terminal circuits.





If 2 or more malfunctions are indicated at the same time, the lowest numbered DTC is displayed first.

d. Refer to the Diagnostic Trouble Code Chart for DTC information.
e. After completing the check, turn the ignition switch OFF and remove the SST from the DLC3.





2. CLEAR THE DTC (USING SST CHECK WIRE)
a. Using the SST, connect terminals 10 (TC) and 4 (CG) of the DLC3.
b. Turn the ignition switch ON.
c. Within 15 seconds after connecting terminals TC and CG, change the tire pressure warning switch between MAIN and 2nd for 4 cycles or more.
d. Check that the multi-information display shows the normal system code.
e. Disconnect the SST from the terminals of the DLC3.





3. DTC CHECK (USING INTELLIGENT TESTER)
a. Connect the intelligent tester (with CAN VIM) to the DLC3.
b. Turn the ignition switch ON.
c. Read the DTCs following the prompts on the tester screen.

HINT: Refer to the intelligent tester operator's manual for further details.

4. CLEAR THE DTC (USING INTELLIGENT TESTER)

HINT: After repairing the malfunctions, clear the DTCs.

a. Connect the intelligent tester (with CAN VIM) to the DLC3.
b. Turn the ignition switch ON.
c. Erase the DTCs following the prompts on the tester screen.

HINT: Refer to the intelligent tester operator's manual for further details.