Diagnosis System

DIAGNOSIS SYSTEM

1. CHECK DLC3
The ECM uses ISO 15765-4 for communication. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 15765-4 format.

Verify Conditions Listed In Table:

If the result is not as specified, the DLC3 may have a malfunction. Repair or replace the harness and connector.

HINT: Connect the cable of the intelligent tester to the DLC3, turn the ignition switch ON and attempt to use the tester. If the display indicates that a communication error has occurred, there is a problem wither with the vehicle or with the tester.

^ If communication is normal when the tester is connected to another vehicle, inspect the DLC3 on the original vehicle.
^ If communication is still not possible when the tool is connected to another vehicle, the problem is probably in the tester itself, so consult the Service Department listed in the tester's instruction manual.

2. DIAGNOSIS SYSTEM
a. Warning light
1. The tire pressure warning light blinks when there is any malfunction in the tire pressure warning system.

NOTICE: When the malfunction has been corrected, the tire pressure warning light does not come on.

b. DTCs (Normal mode)
1. DTCs are memorized in the tire pressure monitor ECU. These DTCs can be read by checking the blinks of the tire pressure warning light or by using the intelligent tester.
c. Test mode
1. By switching from normal mode to test mode (input signal check), you can inspect the tire pressure monitor receiver assembly, each tire pressure monitor valve sub-assembly and vehicle speed sensor.

3. CHECK WARNING LIGHT
a. Turn the ignition switch ON.

b. Check that the tire pressure warning light comes on for 3 seconds.
If the warning check result is not normal, proceed to the troubleshooting for the tire pressure warning light circuit.

4. TIRE PRESSURE WARNING LIGHT CHART

HINT: The table indicates the state of the tire pressure warning light after the ignition switch is turned ON.

*1: Comes on and goes off repeatedly at 0.5 second intervals.

*2: Comes on and goes off repeatedly at 0.125 second intervals.

*3: Blinks 3 times (1 second on, 1 second off).