Front Speed Sensor
FRONT SPEED SENSORCOMPONENTS:
REMOVAL
HINT:
^ Use the same procedures for the LH side and RH side.
^ The procedures listed are for the LH side.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2. REMOVE FRONT WHEEL
3. REMOVE FRONT SPEED SENSOR LH
a. Disconnect the speed sensor connector.
b. Remove the resin clip and 4 clamp bolts holding the sensor harness from the steering knuckle and upper arm.
c. Remove the bolt and speed sensor to the steering knuckle.
NOTICE: Keep the sensor tip and sensor installation hole free from foreign matter.
INSTALLATION
HINT:
^ Use the same procedures for the LH side and RH side.
^ The procedures listed are for the LH side.
1. INSTALL FRONT SPEED SENSOR LH
a. Install the speed sensor to the steering knuckle with the bolt.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
NOTICE: Keep the sensor tip and sensor installation hole free from foreign matter.
b. Install the sensor harness to the steering knuckle and upper arm with the resin clip and 4 clamp bolts.
Torque: 13 Nm (130 kgf-cm, 9 ft. lbs.)
NOTICE: Do not twist the sensor wire when installing it.
c. Connect the speed sensor connector.
NOTICE: Do not twist the sensor wire when installing it.
2. INSTALL FRONT WHEEL
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
4. PERFORM INITIALIZATION
a. Perform initialization.
NOTICE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
5. CHECK ABS SPEED SENSOR SIGNAL
a. Check the ABS speed sensor signal.