Operation CHARM: Car repair manuals for everyone.

Without Scan Tool

CLEAR DTC (USING SST CHECK WIRE)
a. Turn the ignition switch ON.





b. Using SST, connect terminals 12 (TS) and 4 (CG) of DLC3.
SST 09843-18040
c. Disconnect and connect the SST check wire from the terminal 4 (CG) times or more in 8 seconds.
d. Check that the VGRS warning light blinks a normal code.

HINT: If the fault has not been repaired, the code may still be displayed.

e. Turn the ignition switch OFF.
f. Remove the SST check wire from DLC3.
g. Perform the zero point calibration for the deceleration sensor and yaw rate sensor.

HINT: When clearing the VGRS codes, the deceleration sensor and yaw rate sensor memory is also cleared. Therefore it is necessary to complete the zero point calibration.