Actuator Check

DIAGNOSIS SYSTEM




1. LIST OF OPERATION METHODS
By operating each of the A/C control switches as shown in the diagram, it is possible to enter the diagnostic check mode.

ACTUATOR CHECK




a. After entering the DTC check mode (Sensor Check Mode), press the "R/F" switch.
b. At each damper, the motor and relay automatically operate the actuator check at 1 second intervals from step No.1 to No.10 continuously, check the temperature and air flow visually and by hand.
If the slower display is desired, press the "UPDr" switch and change it to step operation. Each time the "UPDr" switch is pressed, the display changes by 1 step.






HINT:
- Codes are displayed from the smaller to the larger numbers in order.
- To cancel the check mode, press the "OFF" switch.