Front Circuit Breaker Sensor
REMOVAL1. DISCONNECT CABLE FROM BATTERY NEGATIVE TERMINAL
2. REMOVE ENGINE ROOM SIDE LH COVER
3. REMOVE AIR CLEANER CAP W/INLET
4. REMOVE CIRCUIT BREAKER SENSOR NO.1
a. Move the outer section to the wire harness side as illustrated, then disconnect the circuit breaker sensor No.1.
b. Remove the 2 bolts and circuit breaker sensor No.1from the w/ converter inverter assembly.
INSTALLATION
1. INSTALL CIRCUIT BREAKER SENSOR NO.1
a. Install the circuit breaker sensor No.1 with the 2bolts to the w/ converter inverter assembly.
Torque: 8.0 N.m (82 kgf.cm, 70 in.lbf)
b. Connect the connector to the circuit breaker sensor No.1.
2. INSTALL AIR CLEANER CAP W/INLET
3. INSTALL ENGINE ROOM SIDE LH COVER
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5. PERFORM INITIALIZATION
Some system need initialization when reconnecting the battery cable.