CAN Communication System
TERMINALS OF ECUHINT: This describes the standard CAN values for all CAN related components.
1. CAN J/C (CAN RH J/C, CAN CENTER J/C)
a. CAN RH J/C.
NOTE:
- The connectors connected to the CAN J/C can be distinguished by the colors of the bus lines and the connecting side of the connector.
- The connectors can be connected to any cables on the same side.
b. CAN Center J/C
NOTE:
- The connectors connected to the CAN J/C can be distinguished by the colors of the bus lines and the connecting side of the connector.
- The connectors can be connected to any cables on the same side.
c. The terminals of the CAN J/C connectors.
d. Measure the resistance according to the value(s) in the table.
e. Wiring diagram for identifying CAN J/C connectors.
2. DLC3
a. Measure the resistance according to the value(s) in the table.
3. SKID CONTROL ECU
a. Disconnect the connectors from the skid control ECU.
b. Measure the resistance according to the value(s) in the table.
4. STEERING SENSOR
a. Disconnect the connector from the steering sensor.
b. Measure the resistance according to the value(s) in the table.
5. YAW RATE SENSOR
a. Disconnect the connector from the yaw rate sensor.
b. Measure the resistance according to the value(s) in the table.
6. HV CONTROL ECU
a. Disconnect the connectors from the HV control ECU.
b. Measure the resistance according to the value(s) in the table.
7. POWER STEERING ECU
a. Disconnect the connector from the power steering ECU.
b. Measure the resistance according to the value(s) in the table.
8. GATEWAY ECU
a. Disconnect the connector from the gateway ECU.
b. Measure the resistance according to the value(s) in the table.
9. DISTANCE CONTROL ECU
a. Disconnect the connector from the distance control ECU.
b. Measure the resistance according to the value(s) in the table.
10. TELEVISION CAMERA ECU
a. Disconnect the connector from the television camera ECU.
b. Measure the resistance according to the value(s) in the table.