Front Seat Assembly (For LH Side)
FRONT SEAT ASSEMBLY (For LH Side)Front Seat Assembly (For LH Side):
Front Seat Assembly (For LH Side):
Front Seat Assembly (For LH Side):
Front Seat Assembly (For LH Side):
Front Seat Assembly (For LH Side):
Front Seat Assembly (For LH Side):
REMOVAL
NOTICE:
- Always wear gloves because the sharp edges of the seatback frame and seat adjuster may cause injury.
- Work must be started 90 seconds after the ignition switch is turned to the LOCK position and the negative (-) terminal cable is disconnected from the battery. (The SRS is equipped with a back-up power source.If work is started within 90 seconds after disconnecting the negative (-) terminal cable of the battery, the SRS may deploy.)
HINT:
- Installation is in the reverse order of removal.However, only installation procedures requiring additional information are included.
- Use the same procedures for the RH side and LH side.
- A bolt without a torque specification is shown in the standard bolt chart.
- COMPONENTS
1. DISCONNECT DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE SEAT TRACK BRACKET COVER OUTER FRONT LH
a. Using a screwdriver, pry out the seat track bracket cover outer front LH.
HINT: Tape the screwdriver tip before use.
3. REMOVE SEAT TRACK BRACKET COVER INNER FRONT LH
HINT: Removal procedure of the seat track bracket cover inner front LH is the same as for the seat track bracket cover outer front LH.
4. REMOVE SEAT TRACK COVER RH
a. Using a screwdriver, pry out the 2 seat track cover RH.
HINT: Tape the screwdriver tip before use.
5. REMOVE FRONT SEAT ASSEMBLY LH
a. Disconnect the connectors under the front LH seat assembly.
b. Remove the 4 bolts and front LH seat assembly.
NOTICE: Be careful not to damage the body.
INSTALLATION
1. INSTALL FRONT SEAT ASSEMBLY LH
a. Place the front LH seat assembly in the cabin.
NOTICE: Be careful not to damage the vehicle body.
b. Connect the connectors under the front LH seat assembly.
c. Install the front LH seat assembly with the 4 bolts.
Torque: 37 N.m (377 kgf.cm, 27 ft.lbf)
2. INSTALL SEAT TRACK COVER RH
3. INSTALL SEAT TRACK BRACKET COVER INNER FRONT LH
4. INSTALL SEAT TRACK BRACKET COVER OUTER FRONT LH
5. CONNECT BATTERY NEGATIVE TERMINAL