Backup Lamp: Service and Repair

Back-Up Light Assembly:

BACK-UP LIGHT ASSEMBLY

REMOVAL

1. REMOVE BACK DOOR GARNISH CENTER
2. REMOVE BACK DOOR SIDE GARNISH RH
3. REMOVE BACK DOOR SIDE GARNISH LH
4. REMOVE TOOL BOX PANEL SUB-ASSEMBLY UPPER
5. REMOVE DOOR PULL HANDLE SUB-ASSEMBLY
6. REMOVE BACK DOOR TRIM BOARD
7. REMOVE BACK DOOR SERVICE HOLE COVER
8. REMOVE LICENSE REAR LIGHT COVER
9. REMOVE BACK DOOR OUTSIDE GARNISH

a. Disconnect the connectors.
b. Remove the 4 nuts.
c. Release the 5 clips, and remove the back door outside garnish.

10. REMOVE BACK-UP LIGHT ASSEMBLY

a. Remove the back up light body gasket LH.
b. Remove the socket with the bulb.
c. Release the 2 claws and remove the back-up light lens & body LH.

INSTALLATION

1. INSTALL BACK-UP LIGHT ASSEMBLY

a. Connect each connector.
b. Install the back-up light assembly.

2. INSTALL BACK DOOR OUTSIDE GARNISH
3. INSTALL LICENSE REAR LIGHT COVER
4. INSTALL BACK DOOR SERVICE HOLE COVER
5. INSTALL BACK DOOR TRIM BOARD
6. INSTALL DOOR PULL HANDLE SUB-ASSEMBLY
7. INSTALL TOOL BOX PANEL SUB-ASSEMBLY UPPER
8. INSTALL BACK DOOR SIDE GARNISH LH
9. INSTALL BACK DOOR SIDE GARNISH RH
10. INSTALL BACK DOOR GARNISH CENTER