Stabilizer Control ECU
REMOVAL1. DISCONNECT BATTERY NEGATIVE TERMINAL
2. REMOVE FRONT DOOR SCUFF PLATE LH
3. REMOVE COWL SIDE TRIM BOARD LH
4. REMOVE INSTRUMENT PANEL UNDER COVER SUBASSEMBLY NO. 1
5. REMOVE INSTRUMENT PANEL FINISH PLATE
6. REMOVE INSTRUMENT PANEL FINISH PANEL SUBASSEMBLY LOWER
7. REMOVE INSTRUMENT PANEL LOWER LH
8. REMOVE SUSPENSION CONTROL ECU
a. Remove the 2 nuts and a bolt, disconnect the junction block.
b. Disconnect the connector from the suspension control ECU.
c. Remove the 2 bolts and the suspension control ECU.
INSTALLATION
1. INSTALL SUSPENSION CONTROL ECU
a. Install the suspension control ECU with the 2 bolts.
Torque: 7.8 N.m (80 kgf.cm, 69 in.lbf)
b. Connect the 3 suspension control ECU connectors.
2. INSTALL INSTRUMENT PANEL LOWER LH
3. INSTALL INSTRUMENT PANEL FINISH PANEL SUBASSEMBLY LOWER
4. INSTALL INSTRUMENT PANEL FINISH PLATE
5. INSTALL INSTRUMENT PANEL UNDER COVER SUBASSEMBLY NO. 1
6. INSTALL COWL SIDE TRIM BOARD LH
7. INSTALL FRONT DOOR SCUFF PLATE LH