Stabilizer Control ECU (W/ KDSS)
REMOVAL1. DISCONNECT BATTERY NEGATIVE TERMINAL
2. REMOVE ROOF SIDE GARNISH INNER LH
HINT: Refer to the procedures up to "REMOVE ROOF SIDE GARNISH INNER LH".
3. REMOVE STABILIZER CONTROL ECU
a. Disconnect the connector.
b. Remove the 2 bolts and stabilizer control ECU.
NOTE:
- Avoid any impact to the stabilizer control ECU.
- Replace the stabilizer control ECU with a new one if it is dropped.
INSTALLATION
1. INSTALL STABILIZER CONTROL ECU
a. Install the stabilizer control ECU with the 2 bolts.
Torque: 7.8 N.m (80 kgf.cm, 69 in.lbf)
b. Connect the connector.
2. INSTALL ROOF SIDE GARNISH INNER LH
HINT: Refer to the procedures from "INSTALL ROOF SIDE GARNISH INNER LH".
3. CONNECT BATTERY NEGATIVE TERMINAL
4. PERFORM ACCELERATION SENSOR ASSEMBLY ZERO POINT CALIBRATION